Battery protector 220A - Victron Energy
Battery protector 220A - Victron Energy
Op voorraad - 1-2 werkdagen levertijd
Gratis bezorging of afhalen
Snel en veilig betalen
Klanten geven vctrade.nl een 4,9/5
14 dagen retour
Product information
Product description
The BatteryProtect disconnects the battery from non-essential loads before the battery is completely discharged (which would damage the battery) or before there is insufficient power left to start the engine.
Automatic detection 12/24V
The BatteryProtect automatically detects the system voltage
Simple programming
The BatteryProtect can be set to switch on/off at different voltages. The 7-segment display shows the selected setting.
A special setting for lithium-ion batteries
In this mode the BatteryProtect can be controlled by the VE.Bus BMS. Please note: the BatteryProtect can also be used as a charge interrupter between a battery charger and a Li-ion battery. See connection diagram in the manual.
Super low power consumption
This is important in the case of lithium-ion batteries, especially after a low voltage shutdown.
Overvoltage protection
To prevent damage to sensitive loads due to overvoltage, the load is disconnected as soon as the DC voltage reaches 16V resp. exceeds 32V.
Protected against ignition
No relays, but MOSFET switches and therefore no sparks.
Delayed alarm
The alarm is activated if the battery voltage drops below the preset disconnect level for more than 12 seconds. Therefore, starting the engine does not activate the alarm. The alarm output is an open-collector, short-circuit proof output connected to the negative (minus) rail, max. current 50mA. The alarm output is generally used to activate the buzzer, an LED or relay.
Delayed load disconnection and delayed reconnection
The load is disconnected 90 seconds after the alarm is activated. If the battery voltage rises back to the coupling threshold within this time frame (after the engine has been started, for example), the load is not disconnected. The load is reconnected 30 seconds after the battery voltage rises above the preset reconnection voltage.
Product specifications
Maximum load current: 220A
Peak current (30 seconds): 600A
Operating voltage range: 6-35V/DC
Operating temperature range: Full load: -40°C to +40°C (up to 60% of rated load at 50°C)
IP Value: Electronics: IP67 (moulded), Connections: IP00
Connection: M8
Weight: 0.8Kg
Dimensions (hxwxd): 62x123x120mm
Battery protector is not designed for reverse current of chargers